MERIDIAN OPTION 11 SYSTEMS

  INSTRUCTIONS FOR FINDING THE PORT NUMBER USING THE EPSON HX20 TERMINAL

NOTE!

  A DOUBLE ENDED FEMALE RS232 CONNECTOR IS REQUIRED

   USING EPSON HX20 TERMINAL                  DISPLAY

SWITCH ON EPSON & PRESS DIGIT 6               6. TERMINAL MODE

PRESS DIGIT 4 TO SELECT THE BAUD RATE         4 = 1200

PRESS DIGIT 8 FOR EIGHT STOP BITS             7 OR 8 STOP BITS

PRESS LETTER N FOR NO PARITY                  PARITY Y/N

PRESS ANY KEY. & CONNECT EPSON RS232
CORD INTO OPTION 11 CORD INSIDE BOX
CONN MARKED "0" WITH SILVER END
CONNECTOR.



TYPE IN "LOGI & PRESS RETURN                  PASS?
TYPE PASSCODE "4321" & PRESS RETURN           >
TYPE IN LD 20" & PRESS RETURN                 REQ
TYPE  IN "PRT" & PRESS RETURN                 TYPE
TYPE  IN "DNB" & PRESS RETURN                 CUST
TYPE  IN "0" & PRESS RETURN                   DN


TYPE IN EXTN NUMBER & PRESS RETURN       
(ALL THE EXTN DETAILS ARE GIVEN.  THE PORT NUMBER IS SHOWN AS.. 
   0X 0 00 0X WHICH MEANS 0X 0X IS THE PORT NUMBER.)  
   MIDDLE DIGITS ARE NOT USED


TYPE IN EXTN NUMBER & PRESS RETURN


TYPE IN **** TO ESCAPE FROM LD 20
OR ANY OTHER PROGRAME IN ORDER TO
ENTER ANOTHER SECTION OR LOG OFF.             >


TYPE IN "LOGO" TO EXIT & UNPLUG
EPSON HX20 TERMINAL


TO FIND OUT DETAILS OF THE PORT
NUMBERS TO EXTN NUMBERS THEN TYPE
IN PROGRAME 81 (LD 81 + RETURN)               REQ


TYPE IN "LST" (LIST) & PRESS RETURN           CUST

PRESS RETURN UNTIL DETAILS ARE LISTED

PRESS "BREAK" TO RETURN EPSON HX20
TO MAIN PROGRAME.